| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Insecure default variable initialization of Intel(R) RealSense(TM) ID Solution F450 before version 2.6.0.74 may allow an unauthenticated user to potentially enable information disclosure via physical access. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: regenerate buddy after block freeing failed if under fc replay
This mostly reverts commit 6bd97bf273bd ("ext4: remove redundant
mb_regenerate_buddy()") and reintroduces mb_regenerate_buddy(). Based on
code in mb_free_blocks(), fast commit replay can end up marking as free
blocks that are already marked as such. This causes corruption of the
buddy bitmap so we need to regenerate it in that case. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: sdio: Honor the host max_req_size in the RX path
Lukas reports skb_over_panic errors on his Banana Pi BPI-CM4 which comes
with an Amlogic A311D (G12B) SoC and a RTL8822CS SDIO wifi/Bluetooth
combo card. The error he observed is identical to what has been fixed
in commit e967229ead0e ("wifi: rtw88: sdio: Check the HISR RX_REQUEST
bit in rtw_sdio_rx_isr()") but that commit didn't fix Lukas' problem.
Lukas found that disabling or limiting RX aggregation works around the
problem for some time (but does not fully fix it). In the following
discussion a few key topics have been discussed which have an impact on
this problem:
- The Amlogic A311D (G12B) SoC has a hardware bug in the SDIO controller
which prevents DMA transfers. Instead all transfers need to go through
the controller SRAM which limits transfers to 1536 bytes
- rtw88 chips don't split incoming (RX) packets, so if a big packet is
received this is forwarded to the host in it's original form
- rtw88 chips can do RX aggregation, meaning more multiple incoming
packets can be pulled by the host from the card with one MMC/SDIO
transfer. This Depends on settings in the REG_RXDMA_AGG_PG_TH
register (BIT_RXDMA_AGG_PG_TH limits the number of packets that will
be aggregated, BIT_DMA_AGG_TO_V1 configures a timeout for aggregation
and BIT_EN_PRE_CALC makes the chip honor the limits more effectively)
Use multiple consecutive reads in rtw_sdio_read_port() and limit the
number of bytes which are copied by the host from the card in one
MMC/SDIO transfer. This allows receiving a buffer that's larger than
the hosts max_req_size (number of bytes which can be transferred in
one MMC/SDIO transfer). As a result of this the skb_over_panic error
is gone as the rtw88 driver is now able to receive more than 1536 bytes
from the card (either because the incoming packet is larger than that
or because multiple packets have been aggregated).
In case of an receive errors (-EILSEQ has been observed by Lukas) we
need to drain the remaining data from the card's buffer, otherwise the
card will return corrupt data for the next rtw_sdio_read_port() call. |
| In the Linux kernel, the following vulnerability has been resolved:
kvm: avoid speculation-based attacks from out-of-range memslot accesses
KVM's mechanism for accessing guest memory translates a guest physical
address (gpa) to a host virtual address using the right-shifted gpa
(also known as gfn) and a struct kvm_memory_slot. The translation is
performed in __gfn_to_hva_memslot using the following formula:
hva = slot->userspace_addr + (gfn - slot->base_gfn) * PAGE_SIZE
It is expected that gfn falls within the boundaries of the guest's
physical memory. However, a guest can access invalid physical addresses
in such a way that the gfn is invalid.
__gfn_to_hva_memslot is called from kvm_vcpu_gfn_to_hva_prot, which first
retrieves a memslot through __gfn_to_memslot. While __gfn_to_memslot
does check that the gfn falls within the boundaries of the guest's
physical memory or not, a CPU can speculate the result of the check and
continue execution speculatively using an illegal gfn. The speculation
can result in calculating an out-of-bounds hva. If the resulting host
virtual address is used to load another guest physical address, this
is effectively a Spectre gadget consisting of two consecutive reads,
the second of which is data dependent on the first.
Right now it's not clear if there are any cases in which this is
exploitable. One interesting case was reported by the original author
of this patch, and involves visiting guest page tables on x86. Right
now these are not vulnerable because the hva read goes through get_user(),
which contains an LFENCE speculation barrier. However, there are
patches in progress for x86 uaccess.h to mask kernel addresses instead of
using LFENCE; once these land, a guest could use speculation to read
from the VMM's ring 3 address space. Other architectures such as ARM
already use the address masking method, and would be susceptible to
this same kind of data-dependent access gadgets. Therefore, this patch
proactively protects from these attacks by masking out-of-bounds gfns
in __gfn_to_hva_memslot, which blocks speculation of invalid hvas.
Sean Christopherson noted that this patch does not cover
kvm_read_guest_offset_cached. This however is limited to a few bytes
past the end of the cache, and therefore it is unlikely to be useful in
the context of building a chain of data dependent accesses. |
| In the Linux kernel, the following vulnerability has been resolved:
ARM: 9063/1: mm: reduce maximum number of CPUs if DEBUG_KMAP_LOCAL is enabled
The debugging code for kmap_local() doubles the number of per-CPU fixmap
slots allocated for kmap_local(), in order to use half of them as guard
regions. This causes the fixmap region to grow downwards beyond the start
of its reserved window if the supported number of CPUs is large, and collide
with the newly added virtual DT mapping right below it, which is obviously
not good.
One manifestation of this is EFI boot on a kernel built with NR_CPUS=32
and CONFIG_DEBUG_KMAP_LOCAL=y, which may pass the FDT in highmem, resulting
in block entries below the fixmap region that the fixmap code misidentifies
as fixmap table entries, and subsequently tries to dereference using a
phys-to-virt translation that is only valid for lowmem. This results in a
cryptic splat such as the one below.
ftrace: allocating 45548 entries in 89 pages
8<--- cut here ---
Unable to handle kernel paging request at virtual address fc6006f0
pgd = (ptrval)
[fc6006f0] *pgd=80000040207003, *pmd=00000000
Internal error: Oops: a06 [#1] SMP ARM
Modules linked in:
CPU: 0 PID: 0 Comm: swapper Not tainted 5.11.0+ #382
Hardware name: Generic DT based system
PC is at cpu_ca15_set_pte_ext+0x24/0x30
LR is at __set_fixmap+0xe4/0x118
pc : [<c041ac9c>] lr : [<c04189d8>] psr: 400000d3
sp : c1601ed8 ip : 00400000 fp : 00800000
r10: 0000071f r9 : 00421000 r8 : 00c00000
r7 : 00c00000 r6 : 0000071f r5 : ffade000 r4 : 4040171f
r3 : 00c00000 r2 : 4040171f r1 : c041ac78 r0 : fc6006f0
Flags: nZcv IRQs off FIQs off Mode SVC_32 ISA ARM Segment none
Control: 30c5387d Table: 40203000 DAC: 00000001
Process swapper (pid: 0, stack limit = 0x(ptrval))
So let's limit CONFIG_NR_CPUS to 16 when CONFIG_DEBUG_KMAP_LOCAL=y. Also,
fix the BUILD_BUG_ON() check that was supposed to catch this, by checking
whether the region grows below the start address rather than above the end
address. |
| In JetBrains RubyMine before 2025.1 remote Interpreter overwrote ports to listen on all interfaces |
| An issue was discovered in Siime Eye 14.1.00000001.3.330.0.0.3.14. It uses a default SSID value, which makes it easier for remote attackers to discover the physical locations of many Siime Eye devices, violating the privacy of users who do not wish to disclose their ownership of this type of device. (Various resources such as wigle.net can be use for mapping of SSIDs to physical locations.) |
| A flaw was found in Openshift. A pod with a DNSPolicy of "ClusterFirst" may incorrectly resolve the hostname based on a service provided. This flaw allows an attacker to supply an incorrect name with the DNS search policy, affecting confidentiality and availability. |
| In JetBrains TeamCity between 2022.10 and 2022.10.1 connecting to AWS using the "Default Credential Provider Chain" allowed TeamCity project administrators to access AWS resources normally limited to TeamCity system administrators. |
| In applyKeyguardFlags of NotificationShadeWindowControllerImpl.java, there is a possible way to observe the user's password on a secondary display due to an insecure default value. This could lead to local information disclosure with no additional execution privileges needed. User interaction is needed for exploitation.Product: AndroidVersions: Android-10 Android-11 Android-12 Android-12L Android-13Android ID: A-179725730 |
| Insecure default settings have been found in recorder products provided by Yokogawa Electric Corporation. The default setting of the authentication function is disabled on the affected products. Therefore, when connected to a network with default settings, anyone can access all functions related to settings and operations. As a result, an attacker can illegally manipulate and configure important data such as measured values and settings.
This issue affects GX10 / GX20 / GP10 / GP20 Paperless Recorders: R5.04.01 or earlier; GM Data Acquisition System: R5.05.01 or earlier; DX1000 / DX2000 / DX1000N Paperless Recorders: R4.21 or earlier; FX1000 Paperless Recorders: R1.31 or earlier; μR10000 / μR20000 Chart Recorders: R1.51 or earlier; MW100 Data Acquisition Units: All versions; DX1000T / DX2000T Paperless Recorders: All versions; CX1000 / CX2000 Paperless Recorders: All versions. |
| A vulnerability has been identified in SIMATIC PCS 7 V8.2 (All versions), SIMATIC PCS 7 V9.0 (All versions < V9.0 SP3 UC06), SIMATIC PCS 7 V9.1 (All versions < V9.1 SP1 UC01), SIMATIC WinCC Runtime Professional V16 and earlier (All versions), SIMATIC WinCC Runtime Professional V17 (All versions < V17 Upd4), SIMATIC WinCC V7.3 (All versions), SIMATIC WinCC V7.4 (All versions < V7.4 SP1 Update 21), SIMATIC WinCC V7.5 (All versions < V7.5 SP2 Update 8). A missing printer configuration on the host could allow an authenticated attacker to escape the WinCC Kiosk Mode. |
| wp-mail.php in WordPress before 4.7.1 might allow remote attackers to bypass intended posting restrictions via a spoofed mail server with the mail.example.com name. |
| Zyxel WRE6505 devices have a default TELNET password of 1234 for the root and admin accounts, which makes it easier for remote attackers to conduct DNS hijacking attacks by reconfiguring the built-in dnshijacker process. |
| Dropbox Lepton 1.2.1 allows DoS (SEGV and application crash) via a malformed lepton file because the code does not ensure setup of a correct number of threads. |
| An issue was discovered on Siemens SICAM RTUs SM-2556 COM Modules with the firmware variants ENOS00, ERAC00, ETA2, ETLS00, MODi00, and DNPi00. The integrated web server (port 80/tcp) of the affected devices could allow unauthenticated remote attackers to execute arbitrary code on the affected device. |
| EMC Elastic Cloud Storage (ECS) before 3.1 is affected by an undocumented account vulnerability that could potentially be leveraged by malicious users to compromise the affected system. |
| An issue was discovered in Pivotal Spring Web Flow through 2.4.5. Applications that do not change the value of the MvcViewFactoryCreator useSpringBinding property which is disabled by default (i.e., set to 'false') can be vulnerable to malicious EL expressions in view states that process form submissions but do not have a sub-element to declare explicit data binding property mappings. NOTE: this issue exists because of an incomplete fix for CVE-2017-4971. |
| A vulnerability in Cisco Aironet 1830 Series and Cisco Aironet 1850 Series Access Points running Cisco Mobility Express Software could allow an unauthenticated, remote attacker to take complete control of an affected device. The vulnerability is due to the existence of default credentials for an affected device that is running Cisco Mobility Express Software, regardless of whether the device is configured as a master, subordinate, or standalone access point. An attacker who has layer 3 connectivity to an affected device could use Secure Shell (SSH) to log in to the device with elevated privileges. A successful exploit could allow the attacker to take complete control of the device. This vulnerability affects Cisco Aironet 1830 Series and Cisco Aironet 1850 Series Access Points that are running an 8.2.x release of Cisco Mobility Express Software prior to Release 8.2.111.0, regardless of whether the device is configured as a master, subordinate, or standalone access point. Release 8.2 was the first release of Cisco Mobility Express Software for next generation Cisco Aironet Access Points. Cisco Bug IDs: CSCva50691. |
| In F5 BIG-IP APM 12.0.0 through 12.1.2 and 13.0.0, an authenticated user with an established access session to the BIG-IP APM system may be able to cause a traffic disruption if the length of the requested URL is less than 16 characters. |
